Kone Amd Door Operator Manual Troubleshooting
Discover the new KONE DX Class connected elevator solutions with built-in connectivity to future-proof your building and deliver a redefined user experience. KONE MonoSpace® DX Discover the machine room-less KONE MonoSpace® DX passenger elevator for. Kon. Elevator Amd Door Lock Roller,Kon. Roller With Bracket Km603150g02 & Km603150g04, Find Complete Details about Kon. Elevator Amd Door Lock Roller,Kon. Roller With Bracket Km603150g02 & Km603150g04,Kone Elevator Amd Door Lock Roller Kone Roller With Bracket Km603150g02 Km60316g06 89770g04. KONE AMD-1 Two panel centre opening AMD-1 door configuration is the most traffic-efficient, allowing exit and entry even before the doors are fully open. KONE AMD-2 AMD-2 is a two panel side opening door. This configuration saves space and shaft width but is not as efficient operationally as centre opening door. KonE offers door operation upgrade packages for every elevator. The installation of an upgrade will be scheduled to best suit your needs. KonE offers four door operator system upgrades to ensure an efficient and reliable door operation. The components of each solution are outlined on the following pages.
Kone Amd Door Operator Manual Transmission
Had an old AMD 2.0 board blow out capacitors. I replaced the board and now I can't seem to get this one to 'learn trip'. I have the manual for this board but everything I do referenced by the manual does not seem to work.
Here is what it is doing now:
•Test buttons work opposite, I need to hit close button to open and open to close. When I press the learn button twice the doors work properly on test, but will go back to reversed buttons after attempting 'learn trip'.
•When performing 'learn trip' the doors will automatically reopen after I run it close - is this normal?
•After cycling the doors about 2 times (the manual suggests no more than 5 cycles) on 'learn trip' the State light flashes as if there is a fault.
•The close end LED does not light up unless I press hard on the connector and even then it quickly turns off after trying to cycle the doors.
•When I think the doors have learned and place the car back on normal operation, the doors never open, but will sometimes answer hall calls.
•The doors will sometimes open very slowly and if the proximity edge beams are broken the doors will slam shut.
*note*
This is a 4-stop EC controller (I believe an older H-800 version) with a Kone AMD 2.0 door operator system. The proximity edge is wired separately to the COP and there is no mechanical safety edge.
I'm starting to believe the issue is due to a bad encoder. I've tried various dips witch configurations but nothing seems to work.
Any and all help is greatly appreciated